How to Address Cracks and Holes in Your Ceiling

Address Cracks and Holes

Every house deals with different problems, and address cracks and holes ceiling are quite common in many of them. This is to be expected as water damage, age, or even poor installation can lead to this. These issues can spiral into much larger problems if they are not fixed in time. Dealing with smaller problems can be done individually, but for larger and more serious issues, hiring someone is recommended. Affordable handyman services Singapore are available in case you need help with a problem.

Determining the Reason behind Ceiling Damage

There are many reasons that can cause the ceiling to have holes and cracks in it, a few examples are listed below:

·       Adequate Settling: A building naturally settles over time and in doing so, causes tiny fissures on the ceiling and walls.

·       Broken Water Supply Lines: Pipes or roofs that are broken can also cause leaking. Leaking can lead to weakening the support, and therefore leads to sagging. If not managed properly it can lead to holes in the ceiling.

·       Fluctuating Temperature and Moisture: If temperature and moisture are not regulated consistently, they can cause expansion and contraction and therefore result in cracks.

·       Drywall Installation: Poor drywall or sponge plaster application can lead to deficiencies that create weak spots.

·       Material Ageing: Due to the material ageing, older houses can suffer with fissures.

How to Repair Ceiling Cracks?

1. Assess the Severity

Begin by examining how deep the crack runs. Surface fractures can be easily patched up, while cracks that are significantly deeper will need more attention. Repairing hairline fissures is comparatively simpler than fixing larger ones, which requires more integrating effort. www.handymanservicessingapore.com/ is here to help you for repairing ceiling cracks.

2. Clean Up the Area

To start, use a putty knife and begin to scrape the area around the crack in order to lift any loose paint or debris that might be in the way. Taking time to clean the area means every filler applied will adhere to the surface properly.

3. Apply Joint Compound

Fill up your putty knife with joint compound and apply it to the fissures. Once it has been properly smoothed out, allow it to dry so you can sand it later on for an even finish.

4. Reinforce Large Cracks

If the fissure is wider than 1/8 of an inch, use some fiber glass tape before you apply joint compound. This will prevent the crack from widening further.

5. Paint with Primer

By applying a matching coat of paint to the area once it has dried and been sanded, you can create a seamless appearance. A final coat of primer can be used to seal the repair.

Repair Strategies for Ceiling Holes

Measure the Hole

If the hole is less than a single inch wide, spackling paste can be used instead. For larger holes, using a patching technique is usually recommended.

Install the Ceiling Patch

For holes that measure up to 6 inches in diameter, cut a piece of drywall that is a little wider than the whole itself. It is then secured with joint compound. The edges should be feathered outwards.

Build-Up Layers

Larger holes may require multiple applications of joint compound. Apply in thin layers and let dry before proceeding to the next layer.

Sand and Paint

Once the area that you applied joint compound to has dried, sand it down with the rest of the ceiling for an even match with the ceiling. Then, apply primer before repainting the entire area to make the patch invisible.

When to Call a Professional

The following tasks might be best serviced by a handyman or specialist:

  • Water Damage: Stains, seepage, and sagging in one’s ceiling require context and root cause analysis, for which the assistance of an expert is warranted.
  • Structural Cracks: Those that are large or expanding risk causing foundation problems and should be assessed by an expert.
  • Recurring Damage: Continuous and undisciplined structural repairs might hint towards deeper problems in a building’s structure.
  • High Ceilings: Working at height is always risky and prone to danger if you lack the right equipment and harnesses.

READ MORE: TRUST WIKI

Leave a Reply

Your email address will not be published. Required fields are marked *